Transmitter Calibration
CML Enterprises provides Pressure, Temperature & Electronic Transmitter Calibration Services and Certification using our high accuracy all-in-one Beamex MC6 calibration equipment. All Calibration and Certification is traceable to National and International measurement standards (N.I.S.T.). We at CML understand the importance of transmitter calibration to maintaining quality and cost controls. For every transmitter received in our shop we perform inspections, initial tests and a full multi point calibration. With our extensive knowledge of transmitters we can repair and offer solutions for a transmitter that no longer meets the necessary standards. We offer quick turn around on all our calibrations to meet our customers’ demands.
We can perform Transmitter Calibrations with these communication protocols:
- HART
- ProfiBus
- Foundation FieldBus
Some of the Pressure Units we support for Pressure Transmitter Calibration:
- PSI
- bar
- inH2O
- ftH2O
- inHg
- kPa
- Pa
- Mbar
Pressure & Vacuum Accuracy & Ranges:
- ±0.01% of Full Scale Accuracy for ranges up to 160 iwc (inches water column)
- ±0.005% of Full Scale Accuracy for ranges -14.5 thru 300 PSI
- ±0.007% of Full Scale Accuracy for ranges 0 thru 9,000 PSI
- ±0.25% of Full Scale Accuracy for ranges above 9,000 PSI
Accuracy & Ranges:
- We can calibrate in either Fahrenheit or Celsius
- ±.01 °C of Full Scale Accuracy for ranges -50°C thru 350°C (-58°F thru 662°F)
Pressure Transmitter Calibration Testing Points:
- 3 Point Up & Down Procedure
- 5 Point Up & Down Procedure
- Custom Point Up & Down Procedure
- *All procedures are N.I.S.T. traceable calibration certifications
Calibration Management Database:
CML offers Calibration Management Database services for all our customers. We store each transmitter in our management system so we can track our customers calibrations year over year to give them a detailed analysis of how their transmitters are performing. This gives our customers a heads up on when a transmitter might be getting close to needing repair or replaced. For more information please see our Calibration Management Database page.